Festo CPX DE Series Manual page 38

1. Pneumatic interfaces
Module parameters: Idle mode channel x
Function no. Access to these module parameters is made via protocol−specific functions
(see the manual for the field bus node).
Description Only relevant for certain field bus protocols.
Idle mode channel x:
Idle state channel x:
Remark With the aid of the so−called Idle mode parametrizing, you can determine the
signal status which the outputs are to assume when switching is made to the
Idle state (see also CPX system manual).
This parameter is not available with all field bus protocols.
Tab. 1/7: Idle mode channel x (channel−specific)
Module parameters: Force channel x
Function no. Access to these module parameters is made via protocol−specific functions
(see the manual for the field bus node).
Description Force mode of outputs channel x:
Force state of outputs channel x:
Remark The Force function enables the manipulation of signal states detached from
actual operating states (see also CPX system manual).
Tab. 1/8: Force channel x (channel−specific)
1−18
Hold last state
Idle state (presetting)
Set output
Reset output (presetting)
Blocked (presetting)
Force state
Set signal
Reset signal (presetting)
Festo P.BE−CPX−EA−E N en 05602d