Festo CPX DE Series Manual page 204

A. Technical appendix
Preparing the plugs
and cables
1
Cable
2
Strain relief
3
Housing
4
Connecting part
5
Knurled nut
6
Thread for connector
socket with knurled
nut
Fig. A/11: Individual parts of plug and cable exit
A−28
Connect the plugs and cables as follows (example):
1. In order to open the socket loosen the centre knurled nut.
2. Open the strain relief on the rear part of the housing.
Then pass the cable through.
1
6
3. Remove 5 mm of insulation from the end of the cable and
fit end sleeves on the strands.
4. Connect the ends of the conductors.
5. Replace the connecting part on the housing of the socket.
Pull the cable back so that there are no loops inside the
housing.
6. Tighten the strain relief.
Festo P.BE−CPX−EA−E N en 05602d
2
3
4
5