Festo CPX DE Series Manual page 182

A. Technical appendix
Technical specifications
General technical specifications of the CPX terminal See CPX system manual
Protection class as per EN 60529
Operating voltage supply for electronics/sensors
(V )
EL/SEN
Rated voltage
Maximum internal current consumption at 24 V
(irrespective of switching status of the valves)
Load voltage supply for valves (V
Rated voltage
Maximum internal current consumption at 24 V
(irrespective of switching status of the valves)
Diagnostic message undervoltage V
ing V , load voltage outside function range)
VAL
Digital outputs (valve solenoid coils)
Short circuit protection at valve output
Maximum current consumption per solenoid coil
out of load voltage V
Rated pick−up current/duration
Nominal current with current reduction
Isolation
Electrical isolation
Between the channels (valve solenoid coils)
Between the operating voltage supply for the
electronics/sensors (V
voltage for the valves (V
Module code [Type code] (CPX−specific)
Module identification (Handheld)
A−6
)
VAL
(monitor
VAL
at 24 V
VAL
) and the load
EL/SEN
)
VAL
VMPA2−FB−EMG−4
IP65, in fitted state (MPA pneumatic module
fitted completely)
24 V DC ±25 %
20 mA
24 V DC ±25 %
Typ. 25 mA
17.5...16.0 V
4 outputs
Yes (electronic)
90 mA / 20 ms
18 mA after 20 ms
Tested with 500 V DC
None
With power supply via manifold sub−base type:
CPX−GE−EV−S: none
...−EV−S−7/8−5POL:
yes
CPX−GE−EV−V...:
yes
81
MPA2G
Festo P.BE−CPX−EA−E N en 05602d
VMPA2−FB−EMS−4
24 V DC ±25 %
Typ. 8 mA
17.5...16.0 V
CPX−GE−EV−S: none
...−EV−S−7/8−5POL:
not permitted
CPX−GE−EV−V...:
not permitted
83
MPA2S