YASKAWA Z1000U Series Quick Start Manual page 57

Frequency Reference 1 (set in b1-01)
Frequency Reference 2
(d1-02 or input terminal A1, A2)
Frequency Reference 3
(d1-03 or input terminal A1, A2)
Frequency Reference 4 (d1-04)
Jog Frequency Reference (d1-17)
<1> The Jog frequency overrides all other frequency references.
n d2-01: Frequency Reference Upper Limit
Sets the maximum frequency reference as a percentage of the maximum output frequency. This limit applies to all frequency
references.
Even if the frequency reference is set to a higher value, the drive internal frequency reference will not exceed this value.
No.
d2-01
n d2-02: Frequency Reference Lower Limit
Sets the minimum frequency reference as a percentage of the maximum output frequency. This limit applies to all frequency
references.
If a lower reference than this value is entered, the drive will run at the limit set to d2-02. If the drive is started with a lower
reference than d2-02, it will accelerate up to d2-02.
No.
d2-02
YASKAWA ELECTRIC TOEP C710636 11E Z1000U HVAC MATRIX Drive Quick Start Guide
Table i.30 Multi-Step Speed Reference and Terminal Switch Combinations
Reference
<1>
Frequency
reference
FWD (REV) Run/Stop
Multi-step Speed Ref. 1
Multi-step Speed Ref. 2
Jog Reference
Figure i.51 Preset Reference Timing Diagram
Parameter Name
Frequency Reference Upper Limit
Parameter Name
Frequency Reference Lower Limit
Internal frequency
reference
d2-01
Operating
range
d2-02
Figure i.52 Frequency Reference: Upper and Lower Limits
i.5 Start-Up Programming and Operation
Multi-Step Speed
H1-oo = 3
OFF
ON
OFF
ON
−
d1-04
d1-03
d1-02
(A2)
d1-01
(A1)
d1-17
ON
ON ON
ON
ON
Frequency Reference Upper Limit
Frequency Reference Lower Limit
Set frequency reference
Multi-Step Speed 2 Jog Reference
H1-oo = 4
OFF
OFF
ON
ON
−
Time
Setting Range
0.0 to 110.0%
Setting Range
0.0 to 110.0%
H1-oo = 6
OFF
OFF
OFF
OFF
ON
Default
100.0%
Default
0.0%
57