Table of Contents
Advertisement
Chapter 6 TDS (Total Dissolved Solids) Measurement
This section describes the procedures to set the conditions of TDS measurement.
6.1 TDS Measurement Setting
The setting procedures for each item are explained below.
6.2 TDS Measurement Mode Setting
56
1.
Tap the channel setting and the measurement
item in the MEAS screen to set "CH2" and
"TDS".
2.
Tap
and tap "CH2 MEAS SET".
The TDS measurement setting items are
displayed.
3.
Select items and set the conditions.
For the TDS measurement, calculation using
LINEAR, 442, EN27888, or NaCl can be selected.
1.
Tap
on the right of the TDS type item.
The TDS type is displayed.
2.
Select the item to set.
3.
Tap
.
The setting applies.
Advertisement
Table of Contents
