Electrode Model Setting; Resist Measurement - Horiba Scientific DS-72G Instruction Manual

Lower limit value entry

5.5 Electrode Model Setting

The electrode model setting in COND measurement applies for Resist measurement
(refer to "3.2.6 Electrode Model Setting" (P.45)).

5.6 Resist Measurement

This section describes the procedures of Resist measurement.
1.
When selecting ON the Alarm, lower limit item,
the Lower limit value, tap
Lower limit value item.
2.
Enter an upper limit value on the numerical-key
screen.
To change the unit (M•m, k•m etc.), tap on
the unit change key on the right of the numerical-
key screen.
3.
Tap .
The setting applies.
To cancel the settings, tap
1.
Press the MEAS key, and tap the channel setting
and the measurement item in the MEAS screen
to set "CH2" and "Resist".
2.
Tap to start measurement.
The measurement value is displayed, and the
HOLD indicator blinks until the reading
stabilizes.
To stop calibration tap
indicator blinks.
When the reading stabilizes, the value is held
and HOLD indicator lights up.
During instantaneous value measurement, or
when a measurement value is held, you can
store the measurement values by tapping
the bottom of the screen.
on the right of the
.
while the HOLD
on
55