Raid System And Device Startup - Siemens SIMATIC IPC1047 Operating Instructions Manual

A.2

RAID system and device startup

Problem
The RAID software reports
the following errors:
The RAID plug-in failed
•
to load, because the
drive is not installed.
The Serial ATA plug-in
•
failed to load, because
the driver is not installed
correctly.
The Intel Matrix
• ®
Storage Console was
unable to load a page
for the following reason:
– A plug-in did not
provide a page for
the selected device
– A plug-in failed to
load
After changing the drive, the
system does not boot from
the RAID system
After changing the drive,
"unused" is indicated for the
relevant SATA port
Computer does not boot or
"Boot device not found" is
displayed
SIMATIC IPC1047
Operating Instructions, 09/2018, A5E45118479-AA
Possible cause
RAID is not activated
RAID system does not have
highest boot priority
System was booted without
functioning drive. The
removable drive bay might
not be switched on.
The boot device is not
•
permitted
The boot device is not in
•
first place of the boot
priority in the BIOS
setup
The boot data carrier is
•
set up with GPT and
UEFI boot is deactivated
in the BIOS setup
A.2 RAID system and device startup
Possible remedy
The messages have no negative effect on the operation of the
device and can be ignored.
Acknowledge the messages.
BIOS setup, Boot menu:
Permit RAID system in the boot priority
•
Set the RAID system to be first in the boot priority order.
•
Reboot the system with a functioning drive.
In the BIOS setup "Boot" menu, permit the boot device in
•
the boot priority
In the BIOS setup "Boot" menu, change the boot priority of
•
the Boot device
Activate UEFI boot in the BIOS setup.
•
Technical support
117