Siemens SIMATIC IPC1047 Operating Instructions Manual page 26

Safety Instructions
2.2 Notes on use
Fault caused by I/O devices
The connection of I/O devices can cause faults in the device.
The result may be personal injury and damage to the machine or plant.
• Only connect I/O devices which are approved for industrial applications in accordance
• I/O devices that are not hotplug-capable may only be connected after the device has
NOTICE
Damage through regenerative feedback
Regenerative feedback of voltage to ground by a connected or installed component can
damage the device.
Connected or built-in I/Os, for example, a USB drive, are not permitted to supply any
voltage to the device.
Regenerative feedback is generally not permitted.
Note
When measuring the counter emf, remember the following:
• The affected IPC must be switched off and the power plug must be plugged in.
• All cables from the system must be connected to the IPC during measurement.
• All other components in the plant must be active.
26
CAUTION
with EN 61000-6-2 and IEC 61000-6-2.
been disconnected from the power supply.
Operating Instructions, 09/2018, A5E45118479-AA
SIMATIC IPC1047