Siemens SIMATIC IPC1047 Operating Instructions Manual page 66

Expanding and assigning parameters to the device
6.5 Expansion cards
4. If necessary, open the cable tie
and remove the cables.
5. Loosen the lock on the slot,
remove the graphics card and
carefully place it on the
mounting base.
The modules face upward as
shown.
6. Unscrew the 3 screws and
remove the sheet metal casing.
7. Remove the connectors.
Installation
Proceed in the reverse order for the installation of the graphics card.
NOTICE
Pay attention to the SATA cable connections
Do not interchange the SATA cables during installation. Note the assignment of the SATA
cables to their slots in step 2.
Damaged cables
When hooking in the fan in step 3, ensure that no SATA or fan cables are caught in
between.
66
Operating Instructions, 09/2018, A5E45118479-AA
SIMATIC IPC1047