Removing And Installing 2.5" Drives From/In Tray - Siemens SIMATIC IPC1047 Operating Instructions Manual

Procedure
Read section "ESD guideline (Page 103)".
Removal
1. Place the tray on the mounting base so that it rests as shown.
2. Pull the two guides of the tray outwardly until the marked nipples release the drive.
3. Only touch the sides of the drive.
4. Remove the drive by lifting it upwards, and place it carefully on the mounting base next to
the tray.
Installation
Proceed in reverse order.
6.4.4

Removing and installing 2.5" drives from/in tray

Requirement
● The tray has been removed, see section
"Removing and installing a tray from/in the drive cage (Page 56)".
● 1 drive
● 1 soft mounting base
SIMATIC IPC1047
Operating Instructions, 09/2018, A5E45118479-AA
Expanding and assigning parameters to the device
6.4 Drives
57