Remove The Fan Cover; Replacing Filters - Siemens SIMATIC IPC1047 Operating Instructions Manual

7.2.2

Remove the fan cover

Procedure
1. Open the front door (see
"Opening the front door
(Page 52)") until the marked lock
releases the fan cover.
2. Take hold of the recessed grip.
3. Open the fan cover in the
direction of the arrow.
7.2.3

Replacing filters

The filter pad is located behind the fan cover.
Note
You may only use filters of the same type. Information about the original spare parts for
SIMATIC PCs is available in the Internet at SIMATIC IPC after-sales information system
(http://www.siemens.com/asis).
Filter pads are available as a pack of 10 under the article number A5E37019277.
Requirement
● The device is disconnected from the power supply, see section "Switching off the device
(Page 46)".
● The front door is open, see section "Opening the front door (Page 52)".
● The fan cover has been removed, see section "Remove the fan cover (Page 75)".
● A filter pad from the pack of 10 A5E37019277
Procedure
1. Remove the filter pad from the fan cover.
2. Insert the new filter pad into the fan cover. It is inserted loosely in the fan cover. When
you insert the filter pad, make sure it lies evenly in the fan cover.
3. Replace the fan cover.
SIMATIC IPC1047
Operating Instructions, 09/2018, A5E45118479-AA
Device maintenance and repair
7.2 Maintenance
75