B-6. Msp-Ts430L092 Active Cable Target Socket Module, Pcb; Msp-Ts430L092 Jp1 Settings - Texas Instruments MSP430 User Manual

www.ti.com
Figure B-6 shows the PCB layout for the Active Cable. The following pinning is possible:
• JP1 has two jumpers (Jumper 1 and Jumper 2) that can be set as shown in
Jumper 1
Off
Off
On
On
• JP2 is for reset. For the standard MSP-TS430L092, this jumper must be set. It sets the reset pin to
high and can also control it. Without this jumper on the MSP-TS430L092, reset is set to zero.
Figure B-6. MSP-TS430L092 Active Cable Target Socket Module, PCB
SLAU278F – May 2009 – Revised December 2010
Submit Documentation Feedback
Table B-3. MSP-TS430L092 JP1 Settings
Jumper 2
Off The active cable has no power and does not function.
The active cable receives power from target socket. For this option, the
On
target socket must have its own power supply.
Off The active cable receives power from the JTAG connector.
The JTAG connector powers the active cable and the target socket. For
On this option, the target socket must not have its own power source, as this
would cause a not defined state.
© 2009–2010, Texas Instruments Incorporated
MSP-TS430L092 Active Cable
Table
Description
B-3.
41
Hardware