Telos Zephyr Xstream User Manual page 284

•
Locate the notch on the SIMM module to your right (towards the rear of the
Xstream).
•
At a 30 degree angle from vertical, insert the SIMM module into its socket. It
should slide in with no resistance. The module will be angled towards you.
•
Using your two thumbs push on the green area near either end of the SIMM
module. The top of the SIMM module should pivot back and the catches on
either side should click. If this does not happen remove the SIMM module (see
step 3, above) and try again.
4) Reinstall top cover
5) You may need to reprogram some of your settings, check them after installing the new
software.
Please return the old SIMM module to Telos, via regular US Mail. Your prompt return of this
module will allow us to continue to offer you upgrades in the future, at the lowest possible cost.
Section 13: Deep Tech Information and Troubleshooting
USER'S MANUAL
272