Telos Zephyr Xstream User Manual page 271

USER'S MANUAL
Group......: Http
Description: Set TCP port, default 1024
Name.......: setMp3port
Parameter..: [<Port>]
Group......: Http
Description: Set Mp3 port default 8000
Batch commands:
<none>
Control via Ethernet using Telnet
You can connect to the same command line described above by using Telnet. To do this on a
Windows machine, simply run Telnet. Then type :
Open 123.345.678.901 <enter>
(or select open from the file menu, depending on the Telnet client you are using).
Substitute the IP address of your Xstream for the IP address shown. You can now login to the
Xstream and use the command language as described above.
Telnet is port 23. If you have difficulties with access through a firewall give this information to
your network administrator.
Some versions of Hyper Terminal support Telnet sessions as well. Or, you may be able to enter
the following in your browser: Telenet:123.345.678.901 <enter>
You will need to login in as described previously. Type: Login Telos <Enter> (if this does not
work use Login <Enter>).
NOTE: The Password can only be changed using the RS‐232 or Telnet command line. See section
12.2 for details.
Control via Ethernet with Web Browser
The Xstream can be controlled via a web browser. Of course the computer with the browser and
the Xstream must be both connected to a TCP/IP network. Simply enter:
http://109.876.543.210/ (substitute the IP address of your Xstream) on your browser.
NOTE: The login procedure and web pages are different depending on whether you have the 10
Base‐T or 100 Base‐T (Livewire capable) hardware. Follow the corresponding instructions,
below:
10 Base‐T units (original hardware)
A login page will be displayed. For "password" type: (if this does not work
"Telos <Enter>"
use
"<Enter>").
100 Base‐T units (later, Livewire capable units)
You will need to login in. If requested for a user name, enter "user". By default, there is no
password.
Section 12: System Functions and Remote Control 259