Telos Zephyr Xstream User Manual page 241

Contrast
This allows you to change the contrast of Xstream's LCD display to accommodate differing room
lighting or viewing angles.
Volume
No, this doesn't belong in the AUDIO menu! This volume selection is to adjust the volume of the
different sounds the Xstream makes when keys are pressed, calls connect or other things
happen.
rs232
This allows you to easily set the bit rate of the Zephyr Xstream's RS‐232 port on the rear panel.
Rates from 300 bps to 57.6 kbps are supported. The other serial port parameters are:
•
•
•
•
About
This gives you information about your Xstream.
SYSTEM - Screen 3
Pressing the SYSTEM button a third time shows this screen with the selections needed to
configure your IP (Internet Protocol) settings. You won't need to enter this information to
operate the unit from the front panel. You will need to enter this information if you will be
connecting to the Xstream's Ethernet port (i.e. will be using the Ethernet mode, or will be
controlling the unit remotely using this port).
You will also need to enter these items when the time comes to update the Xstream's operating
software.
USER'S MANUAL
Data Bits: 8 bits
Parity: None
Stop Bits: 1
Flow control: none
Section 11: THE WORKS – Detailed Menu Reference 229