Telos Zephyr Xstream User Manual page 280

2. Start the Telos update server by double clicking.
It is important that the download process completed without interruption. If local
power is not reliable, you might wish to place the Zephyr Xstream (and local FTP server,
if used) on an un‐interruptible power supply.
3. Connect the computer to be used for the update and the Zephyr Xstream to the
same Ethernet network. The following diagram shows the usual connections. Note
that a direct connection between the Xstream and the computer may be made, if
the appropriate Ethernet "Crossover" cable is used. See Appendix 5 (Modular Cable
Guide) for details on that cable, if needed.
4. Program the following information into your Zephyr Xstream. Ask your network
administrator if you need help.
5. Press the <SYSTEM> button three times
6. Enter the following information in this menu:
IP Address‐
The IP address for this unit. As with any computer on an IP network, the
Xstream must have an IP address before it can be used over the network.
SN Mask‐
The subnet mask is to determine the size of your local network. All packets
addressed to a destination outside this local area are sent to the gateway
node entered in the next selection. Normally you should enter
255.255.255.0 here.
Press <SYSTEM> again and enter:
FTP site ‐
This is the IP address of the computer running the Telos Update FTP server.
7. Update the system
Section 13: Deep Tech Information and Troubleshooting
USER'S MANUAL
Standard
Ethernet
Cables
268