Installing The Batteries; Using The Remote Control; Connections; Connecting The Antenna And Lnb (Low Noise Block) To The Receiver - Strong tivu on! tivusat SRT 7840 Manual

2.7 Installing the batteries

Remove the battery cover from the remote control and put 2x AAA size batteries inside the compartment.
The diagram inside the battery compartment shows the correct way to install the batteries.
1. Open the cover
2. Install batteries
3. Close the cover
NOTE:

2.8 Using the remote control

To use the remote control, point it towards the front of the digital receiver. The remote control has a range of
up to 7 metres from the receiver, if properly aligned towards the IR eye on the front panel.
The remote control will not operate if its path is blocked.
NOTE:

3.0 CONNECTIONS

This section explains the most important functions to ensure that you can directly watch television with your
new receiver. Please note additional adjustments may be required.
NOTE:

3.1 Connecting the antenna and LNB (Low Noise Block) to the receiver

Connect the LNB of your satellite antenna to the SAT IN connector of your receiver using a good quality coaxial
cable and suitable 'F-connector' plugs.
3.1.1 Connection of multiple fixed antennas via DiSEqC 1.0
1. Connect the LNBs of your fixed antenna to the inputs of a DiSEqC 1.0 switch using a good quality
coaxial cable and suitable 'F-connectors' .
2. Connect the output or "to receiver" of the DiSEqC 1.0 switch to the SAT IN connector on your
receiver. Use good quality coaxial cable and suitable "F-connectors".
3. Plug the power adapter jack to the receiver and the other end to a suitable wall outlet.

3.2 Connecting to a digital audio amplifier

Connect one end of a good quality optical audio cable to the S/PDIF output of your receiver and the other end
to the optical audio input of your home theatre, amplifier or any other device supporting digital audio.
8
The batteries should not be recharged, disassembled, electrically short-circuited,
be mixed or used with other types of batteries.
Sunlight or very bright light might decrease the sensitivity of the remote control.
Do not connect the receiver to the main power yet.
English
Fig. 6
Fig. 7
Fig. 8
Fig. 8
Fig. 8