Table of Contents
Advertisement
English
7.1.1 Direct access
To gain direct access to a certain channel simply enter its number with the 0~9 keys on the remote control.
Channel numbers can be up to 4 digits long. Entering numbers and values with less than 4 digits is possible.
Just wait a few seconds and your receiver will switch to the selected channel.
7.1.2 Channel list
Press OK or the LIST button in viewing mode to display the channel list.
Use p q to highlight your channel of choice and press OK to select the highlighted channel for preview. Use
the FAV button to get access to a group of favourite lists. Press OK to select only channels from a particular list.
Refer to chapter 8.2.2 TV Channel Manager to organize channels into favourite lists.
The channel list is equipped with a Channel Filter function to make it easier to find channels. Use RED button
to get access to TV Program List filter. There are 4 options to help to find channel. Use pq to select option.
Use t u to switch between Order option, Clas parameter and Programme list.
Use OK to confirm selection.
ALL
for sequential search through complete list of all channels, which are stored in your receiver
from all satellites.
A-Z
to search for the channel from the list in alphabetical order. In Group parameter define first
letter of channel name. At right side on screen you will see only channels, which name
starting from selected letter.
FAV
to search for the channel within your favourite lists.
SAT
to search for the channel by satellites, which channels were stored to receiver.
NOTE:
The channel list is also equipped with another option to facilitate the search for a channel. Use the GREEN
button to display the search engine and insert the name of the channel you need to find. Use p q and t u
to compose the channel name then press RED button to search or EXIT to select the channel list with the
search results on the left.
7.1.3 Using the
CH
CH
or p will switch to a higher channel.
CH
or q will switch a lower channel.
7.1.4 Using the BACK button
Use the BACK button to return to the last viewed channel. By pressing this button, the receiver displays the TV
recent list. This list contains the last channels viewed. Use p q to select the channel you need then confirm
with OK.
7.2 Volume Control
The volume control allows you to adjust the audio volume. Press V+/- or t u button to adjust the audio
volume. Press the ! button to temporarily mute audio. Press it again to come back to normal volume.
NOTE:
The bottom row on the screen provides technical information of the selected
channel.
or
buttons
/CH
p
q
The ! function remains set while you switch channels.
11
Advertisement
Table of Contents
