Table of Contents
Advertisement
English
1.5 Usage of external USB devices
It is recommended to use USB 2.0 storage devices. If your device is not compatible to USB 2.0
„
„
specifications, the playback with your receiver might not work properly.
If you are going to use external USB HDD (Hard Disk Drive) please consider that the power
„
„
specifications might exceed the supported output of your receiver (5 V/800 mA). If so, please
connect your USB HDD to an according external power adapter.
STRONG cannot guarantee compatibility with all types of USB storage devices.
„
„
It is advised not to store important information on USB storage devices used with the receiver.
„
„
Always make backups of data on your USB storage device before using it with this receiver.
STRONG will not take responsibility for any loss of information or circumstances caused by loss of
information.
Please ensure that either the USB device is already formatted to NTFS or FAT32 or format the USB
„
„
device via your receiver. Formatting requires entering the PIN code (default 0000)
STRONG cannot guarantee the playback of all files although extensions are listed, as it depends on
„
„
file size, codec, bit rate and resolution.
2.0 YOUR RECEIVER
2.1 PIN CODE
The PIN code is set by the user during the installation wizard. To modify the code, go to the Setting menu,
Parental Control > PIN-Code Change.
2.2 Front Panel
1. IR Sensor
2. LED Display Displays channel number, time, videotext page or recording modes
3. Wi-Fi LED:
2.3 Top cover
1. Standby indicator:
2.4 Side Panel
1. Smart card slot
2. USB
2.5 Rear Panel
1. SAT IN
2. TV SCART
3. S/PDIF (optical)
4. HDMI
5. USB
6. ETHERNET
7. IR
Receives the commands of the remote control
Shows the status of your Wi-Fi connection. GREEN: connection OK. GREEN
BLINKING: data transmit. NO LIGHT: no Internet connections.
Shows power state of the receiver. White LED: the receiver is on. Less white LED: the
receiver is in standby mode.
To insert your tivùsat smart card with the golden chip facing down.
To connect your USB storage device
To connect to the LNB of your satellite antenna for reception of satellite broadcast
signal
To connect to TV using a SCART cable
To connect to a digital amplifier or home theatre using a optical cable
To connect to the HDMI input of your TV set using a good quality HDMI cable
To connect your USB (3.0) storage device
To connect to a network switch, router or modem
To connect an infrared sensor (not included in the packaging)
Fig.1
Fig.2
Fig.3
Fig. 4
5
Advertisement
Table of Contents
