Nmea Output Messages; Nmea Input Messages - FALCOM JP7-T Series Hardware Description

GPS-RECEIVER JP7-T

7.2.1 NMEA output messages

Table 9 lists all NMEA output messages supported by SiRFstarIIe
evaluation receiver and a brief description.
Option
GGA
GLL
GSA GPS receiver operating mode, satellites used in the position solution and
GSV The number of GPS satellites in view satellite ID numbers, elevation,
MSS (This message can be switched on via SiRFdemo software) Signal-to-noise
ratio, signal strength, frequency and bit rate from a radio-beacon receiver.
RMC
VTG
Table 9:

NMEA input messages

7.2.2
Message
Set Serial Port
Navigation Initialization
Set DGPS Port
Query/Rate Control
LLA Navigation Initialization
Development Data On/Off
MSK Receiver Interface
Table 10:
1. Message Identification (MID).
2. Input co-ordinates must be WGS84.
3. Input co-ordinates must be WGS84.
This confidential document is the property of FALCOM GmbH and may not be copied or circulated without permission.
Time, position and fix type data.
Latitude, longitude, UTC time of position fix and status.
azimuth and SNR values.
Time, date, position, course and speed data.
Course and speed information relative to the ground.
NMEA Output Messages
1
MID
100
101
102
103
104
105
MSK
NMEA Input Messages
Description
DOP values.
Description
Set PORT A parameters and protocol
Parameters required for start using X/Y/Z
Set PORT B parameters for DGPS input
Query standard NMEA message and/or set
output rate
Parameters required for start using
Lat/Lon/Alt
Development Data messages On/Off
Command message to a MSK radio-beacon
receiver.
VERSION 1.02
2
3
Page 37