FALCOM JP7-T Series Hardware Description page 23

GPS-RECEIVER JP7-T
6.5.1.8 Dynamic Conditions
Altitude
Velocity
Acceleration
Jerk
6.5.1.9 DC Power
Main power
Continuous mode
Backup battery power
6.5.1.10 Serial Port
Electrical interface
Protocol messages
DGPS protocol
6.5.1.11 Time – 1PPS Pulse
Level
Pulse duration
Time reference
Measurements
6.5.1.12 TCXO-Specification
Typical phase noise density 1 Hz offset
Typical phase noise density 10 Hz offset
Typical phase noise density 100 Hz offset
Typical phase noise density 1 kHz offset
Typical phase noise density 10 kHz offset
Load sensitivity
Long term stability
This confidential document is the property of FALCOM GmbH and may not be copied or circulated without permission.
18,000 meters (60,000 feet) max.
<515 meters/second (1000 knots) max.
4 g, max.
20 meters/second³, max.
+ 3.3 V DC ±5 %
65 mA at 3.3 V DC
+3 V DC ±5%
Two full duplex serial communication,
CMOS.
SiRF binary and NMEA-0183, version 2.32
with a baud rate selection
SiRF binary – position, velocity, altitude,
status and control NMEA – GGA, GLL,
GSA, GSV, RMC and VTG
RTCM SC-104, version 2.32, type 1, 5 and
9
CMOS
100 ms
At the pulse positive edge
Aligned to GPS second, ± microsecond
± 10% load change
Frequency drift over 1 year 0.5 to 2.0 ± ppm
VERSION 1.02
-57.0 dBc/Hz
-88.0 dBc/Hz
-112.0 dBc/Hz
-130.0 dBc/Hz
-140.0 dBc/Hz
0.2 ± ppm
Page 23