Changing Front Axle Case Oil (N); Changing Front Axle Case Oil (N) - Kioti DK4810 Manual

(1) oil Dipstick (2) oil filler Plug
(a) oil level is acceptable within this range
5. Apply a thin film of clean oil onto
the O-ring of a new filter.
6. Tighten the filter until it touches the
mounting surface. then, tighten
the filter for a half turn further with
a hand.
7. After installing a new filter, run the
engine for a few minutes and stop
it.
8. check the oil level again and add
more oil to the specified level.
TD200-호주향-DK4810,5310,5810(HS)-017 17
Oil Capacity
11.36 u.s.gal. (43 l)
CAUTION
To avoid injury:
• Be sure to stop the engine
before changing the fluid or
replacing the filter.
• Cool down the fluid sufficien-
td2O704A
tly. you can get burnt by hot
fluid.
IMPORTANT
• To prevent serious damage to
the hydraulic system, use only
a KIOTI genuine filter.
• Do not operate the tractor im-
mediately after changing tran-
smission fluid. Run the engine
at medium speed for a few
minutes to prevent damage to
the hydraulic system.
maintenance
ChANGING fRONT AxlE CAsE
OIl (N)
(1) oil filler Plug (2) Drain Plug
1. remove the drain plugs from the
front axle case (lh/rh) and front
axle support to drain oil.
2. after draining, reinstall the drain
plugs securely.
3. remove the bleeding plug from the
front axle case and add oil through
the filler hole.
7
- 17
td2O714A
5 7
2015-02-11 오후 3:01:23