Flush Cooling System And Changing Coolant (Aj); Flush Cooling System And Changing Coolant (Aj) - Kioti DK4810 Manual

2. unscrew the air cleaner clip and
remove the cover.
3. clean the inside of the air cleaner
housing thoroughly.
4. replace the filter and check the
housing for damage.
5. Install the cover and fix it with the clip.
NOTE
• when installing the cover, make
sure that the dust collection val-
ve is heading down.
CAUTION
• Use only a KIOTI genuine fil-
ter. If using a product other
than the genuine one, it can
damage the engine internal
section and sensor.
• Make sure that no dust enters
the system by installing the
cover firmly.
• When removing the filter, be
careful not to let foreign ma-
terial enter the air inlet.
TD200-호주향-DK4810,5310,5810(HS)-029 29

flUsh COOlING sysTEM AND ChANGING COOlANT (AJ)

(1) Drain Plug
1. Park the tractor on level ground, stop
the engine and let the engine cool down.
2. to drain coolant, remove the drain
plug from the radiator and turn the
radiator cap to the 1st notch to
release pressure in the radiator.
then, remove the cap completely.
3. After all coolant is drained, fit the
drain plug.
4. use clean, fresh water and anti-free-
ze to fill the reservoir tank.
5. follow the cleaner manufacture's
instruction.
td2O731A
(1) radiator cap
(a) full
6. install the radiator cap securely.
7. start and idle the engine for few
minutes.
8. stop the engine and let it cool.
9. Drain water and cooling system
cleaner and close drain cock.
then, fill with antifreeze and
water mixture and close radiator
cap securely.
10. run tractor at idle until up to ope-
rating temperature.
7
- 2
maintenance
td2O732A
(2) reservoir tank
(B) low
5 7
2015-02-11 오후 3:01:26