(1) key Switch
(A) preheat
(B) oFF
(c) Acc
(d) oN
8. Insert the key into the key cylinder,
turn it to the "oN" position and wait
until the glow plug indicator goes
off (Approx. 8 seconds).
If automatic pre-heating is not suf-
ficient, turn and hold the key to the
position "A" (Manual pre-heating)
for a few seconds for manual pre-
heating. during the same seconds,
the glow plug indicator on the dash
board illuminates.
TD200-호주향-DK4810,5310,5810(HS)-05 5
It is normal that the charge war-
ning lamp and engine oil pressure
warning lamps come on when the
key is in "oN" position before the
engine starts.
WARNING
Never operate the start motor
•
for more than 10 consecutive
seconds as it consumes an
td2O404B
excess of battery power. If
the engine cannot be started
within 10 seconds, wait for 30
(E) START
seconds and try again.
When trying to start the engine
•
again, wait until the flywheel
is completely stopped.
9. When the engine is started, re-
lease the key. Then, the key is
automatically turned back to the
"oN" position.
10. Warm up the engine for 3 to 4
minutes (10 minutes in winter)
after releasing the clutch pedal.
opERATIoN
(1) Instrument cluster
(2) Engine oil pressure Warning lamp
(3) charge Warning lamp
11. check to see that all the warning
lamps on the instrument cluster
turn "oFF".
If any lamp remains on, immediately
stop the engine and determine the
cause.
5
5
-
td2O503a
5
2015-02-11 오후 2:59:08