Dpf Regeneration Switch; Dpf Regeneration Switch - Kioti DK4810 Manual

4
12 dK4810/5310/5810(hs)
-
how to deactivate pto cruise
depress the brake or clutch pedal
or turn off the pto cruise switch to
deactivate the function.
if the pto cruise is deactivated by
depressing the brake or clutch pedal
with the pto cruise switch in the "on"
position, pressing the res (+) switch
once resumes the function to the
previous state.
important
• the pto cruise is not deac-
tivated when depressing one
of the brake pedals with the
brake pedals disconnected
from each other.
TD200-호주향-DK4810,5310,5810(HS)-012 12

dpF regeneration switch

(1) dpF regeneration switch

(a) activation (b) deactivation
activation (upper portion oF
switch)
perform the following instructions
when the regeneration warning lamp
comes on (see page 4-17):
1. Park tractor on a flat surface.
2. idle the engine.
3. depress the brake pedals and stop
the vehicle.
4. place all of the shift lever to the
neutral position.
5. run the engine for 3 to 4 minutes.
then, press the activation portion
of the regeneration switch. (approx.
2 seconds.)
note
•
the regeneration underway
lamp is turned on when the dpF
temperature reaches a certain
temperature.
6. the regeneration warning lamp
td2O412A
goes off and regeneration process
lamp blinks.
before resuming your work, wait
for approx. 30 to 40 minutes until
the regeneration process is com-
pleted.
deactivation (lower portion
oF switch)
do not press the deactivation portion
of the switch while the regeneration
process is activated.
however, the switch can be set to
the deactivation position to stop the
regeneration process in emergency.
2015-02-11 오후 2:58:03