Sony MKS-9011A Installation Manual page 20

Connecting procedure
1. Remove the module covers. Remove the screws (BV3
x 10) fixing the caps (L) and (R), and remove the caps
in the direction of the arrow.
2. Loosen the four screws (with drop-safe) fixing the
operation module.
3. Hold the two screws (with drop-safe) in the front of
the both sides of the operation module, and remove the
operation module.
Module covers
Cap (L)
BV3 x 10
Scrwes
(with drop-safe)
Operation module
4. Remove the screws (BV3 x 10) fixing the side plates
to the adaptor case, and remove the side plates.
BV3 x 10
Adaptor case
1-14
Scrwes
(with drop-safe)
BV3 x 10
Cap (R)
Side plates
BV3 x 10
When the Vertical connection is selected
(1) Connect the adaptor cases together.
(Be careful of the direction of the adaptor cases. See the
instruction given on the bottom of the adaptor case.)
(2) Fix the right sides and left sides of the adaptor cases as
shown in the illustration using the two pieces of the con-
necting plate A.
. When fixing the adaptor cases, you can select either
the flat connection or the connection like a flight of
steps.
. When selecting the connection like steps of the
connection method (A), (see Fig. 2 (on page 1-16).)
the two screws are secured with one notch offset
each other.
. When the flat connection method (B, C) is selected,
(see Fig. 2 (on page 1-16).) the two screws are
secured in the same height.
Adaptor cases
Connecting
plate A
BV 3 x 10
Instruction given on
the bottom of the case
Connecting
BV 3 x 10
plate A
CCP-9000A