Installation To Mks-8075A (Extension Adaptor) - Sony MKS-9011A Installation Manual

n
Removal
1. Remove the screw which secures the release lever.
2. Turn the release lever in either of the following
direction.
To remove the HK-PSU11 on slot A : 2
To remove the HK-PSU11 on slot B : 3
3. Remove the HK-PSU11.
Slot B
B3 x 6
Release lever
1-12
Slot A
Slot B
Slot A
1-6-2. Installation to MKS-8075A (Extension
Adaptor)
c
Be sure to disconnect the power cord before starting to
install modules.
If installation of modules is started with the POWER
switch left on, it may cause electrical shock damage
printed circuit boards.
Applicable modules
. MKS-8031ATB Track Ball Module
. MKS-8032A
DKS Fader Module
. MKS-8033A
Utility/Shotbox Module
. MKS-8035A Key Control Module
Installation
1. Remove the module cover on both sides of the opera-
tion module that you want to remove, as shown.
2. Loosen the four screws (with drop-safe) fixing the
operation module.
3. Remove the operation module by holding the two
screws on the sides of the operation module.
4. Fit the operation module that you want to install into
the position as described in step 3. Fix the operation
module by tightening the four screws (with drop-safe)
on both sides.
CCP-9000A