Physiomed vocaSTIM-Master Operating Instructions Manual page 34

Therapy
(5) Set the release time R > 1s and the tension time T to the left to the manual
release key position.
(6) Select the ramp of the current rise.
(7) Select the frequency of modulation.
(8) If necessary, alter the basic frequency.
(9) Activate the acoustic signal, if desired.
(10) Set the therapy time.
(11) Set the time for treatment before turning up the intensity. While keeping the
manual release key depressed, slowly turn up the intensity (intensity
control <6>) until muscle contraction is sufficient. Therapy time elapses.
Note
This safety interruption also appears in case the intensity is turned up
by more than 5.0 mA between pulses while the manual release key is
kept depressed. Whenever this message appears, slowly turn down
the intensity. The message will disappear as soon as the previously set
value is reached again.
(12) Release the button.
If the manual release key is pressed again, the current at
increase automatically and will keep the set intensity as long as the manual
release key is pressed. After releasing the button, the intensity will
automatically be reduced in intervals.
(13) Signs of fatigue should stop the treatment (they may already occur after a few
muscle contractions)!
(14) After treatment, an acoustic signal will be issued. Turn the intensity down to 0.
(15) Remove the electrodes.
28
If the intensity is turned up during release time, the
following message appears in the lower status bar <4>:
and will
FaS HVS
vocaSTIM -Master
®