Target Group; Designated Use; Hoist Applications - SEW-Eurodrive MOVI-C Controller Power UHX85A Manual

Safety notes
2

Target group

2.3 Target group
Specialist for me-
chanical work
Specialist for elec-
trotechnical work
Additional qualifi-
cation
Instructed persons
2.4

Designated use

2.4.1

Hoist applications

10
®
Manual – MOVI-C
Any mechanical work may only be performed by adequately qualified specialists. Spe-
cialists in the context of this documentation are persons familiar with the design, me-
chanical installation, troubleshooting, and maintenance of the product who possess
the following qualifications:
• Qualification in the mechanical area in accordance with the national regulations
• Familiarity with this documentation
Any electrotechnical work may only be performed by electrically skilled persons with a
suitable education. Electrically skilled persons in the context of this documentation are
persons familiar with electrical installation, startup, troubleshooting, and maintenance
of the product who possess the following qualifications:
• Qualification in the electrotechnical area in accordance with the national regula-
tions
• Familiarity with this documentation
In addition to that, these persons must be familiar with the valid safety regulations and
laws, as well as with the requirements of the standards, directives, and laws specified
in this documentation. The persons must have the express authorization of the com-
pany to operate, program, parameterize, label, and ground units, systems, and circuits
in accordance with the standards of safety technology.
All work in the areas of transportation, storage, operation and waste disposal must be
carried out by persons who are trained appropriately. The purpose of the instruction is
that the persons are capable of performing the required tasks and work steps in a safe
and correct manner.
The product is intended for control cabinet installation in electrical plants or machines.
In case of installation in electrical systems or machines, startup of the product is pro-
hibited until it is determined that the machine meets the requirements stipulated in the
local laws and directives. For Europe, Machinery Directive 2006/42/EC as well as the
EMC Directive 2014/30/EU apply. Observe EN 60204-1 (Safety of machinery -– elec-
trical equipment of machines).
Technical data and information on the connection conditions are provided on the
nameplate and in chapter "Technical data" in the documentation. Always comply with
the data and conditions.
Unintended or improper use of the product may result in severe injury to persons and
damage to property.
To avoid danger of fatal injury by falling hoists, observe the following points when us-
ing the product in lifting applications:
• Use mechanical protection devices.
• Perform a hoist startup.
CONTROLLER power UHX85A