Target Group; Designated Use; Functional Safety Technology - SEW-Eurodrive MOVIPRO PHC11A-M1-2A-A1 Series Operating Instructions Manual

2
Safety notes

Target group

2.3 Target group
2.4

Designated use

2.5

Functional safety technology

10
Operating Instructions – MOVIPRO
Mechanical work of any kind may be carried out only by trained specialists. Qualified
personnel in the context of this documentation are persons who are familiar with the
design, mechanical installation, troubleshooting and maintenance of the product and
have the following qualifications:
• Training in mechanical engineering, e.g. as a machinist or mechatronics technician
(final examinations must have been passed).
• Knowledge of this documentation.
Electrical work of any kind may be carried out only by skilled persons. In the context of
this documentation, skilled persons are persons who are familiar with the electrical in-
stallation, startup, troubleshooting and maintenance of the product and who have the
following qualifications:
• Training in electrical engineering, e.g. as an electrician or mechatronics technician
(final examinations must have been passed).
• Knowledge of this documentation.
In addition to that, they must be familiar with the relevant safety regulations and laws,
especially with the requirements of the performance levels according to
DIN EN ISO 13849-1 and all other standards, directives and laws specified in this doc-
umentation. The above-mentioned persons must have the express authorization of the
company to operate, program, parameterize, identify and ground units, systems and
circuits in accordance with safety technology standards.
All work in the areas of transportation, storage, operation and waste disposal must be
performed by suitably trained personnel.
The device is intended for installation in electrical plants or machines. The device can
be used in mobile and stationary operation in industrial and commercial plants for the
operation of AC asynchronous motors with squirrel cage rotor or permanent-field AC
synchronous motors. The motors must be suitable for operation with frequency inver-
ters. Do not connect any other loads to the device. The device can take on control and
communication tasks.
In case of installation in electrical systems or machines, startup of the device (i.e. start
of designated operation) is prohibited until it is determined that the machine meets the
requirements stipulated in the EC Directive 2006/42/EC (Machinery Directive). Ob-
serve standard EN 60204-1. Startup (i.e. the start of designated use) is only permitted
under observance of the EMC Directive (2004/108/EC).
The device meets the requirements stipulated in the low voltage directive 2006/95/EC.
The standards included in the declaration of conformity are used for the unit.
Technical data and information on the connection conditions are provided on the
nameplate and in the documentation. Always comply with the data and conditions.
The unit may not perform safety functions without higher-level safety systems unless
these functions are described and expressly permitted in the relevant documentation.
®
PHC11A-..M1-..2A-A1/..