Integrating And Configuring The Movi-C; Controller In The Fieldbus Network - SEW-Eurodrive MOVI-C Controller Power UHX85A Manual

4. Set the correct firmware version of the EtherNet/IP™ scanner.
5. Enter the IP address of the EtherNet/IP™ scanner. You can find the IP address on
5.4.5 Integrating and configuring the MOVI‑C
The MOVI‑C
nected to the PLC, and configured.
During configuration, the MOVI‑C
address, and process data with addresses.
Proceed as follows:
ü You
ü You have configured the EtherNet/IP™ scanner in the Logix Designer.
the display of the hardware module.
ð In this example, the name of the EtherNet/IP™ scanner is: EtherNetIPScanner.
The IP address of the EtherNet/IP™ scanner is: 192.168.10.39
®
CONTROLLER must also be added to the Logix Designer project, con-
have already downloaded
®
MOVI‑C CONTROLLER from the SEW‑EURODRIVE website → www.sew-
eurodrive.com and saved it locally to the engineering PC (see the chapter "In-
stalling the device description file of the MOVI‑C
Startup with EtherNet/IP™
Configuration of the fieldbus stations
®

CONTROLLER in the fieldbus network

®
CONTROLLER is assigned a logical name, an IP
the device
®
CONTROLLER" (→ 2 51)).
Manual – MOVI-C
24493782411
description file () of
®
CONTROLLER power UHX85A
5
the
55