Removing The Cable; Power On, Sleep, Power Off, Reboot - Newland HR42 Halibut User Manual

Removing the Cable

Get an appropriate needle or a straightened paper clip and then follow the steps below:
1. Disconnect the power adapter from mains if there is one.
2. Insert the needle into the hole.
3. Pull out the cable slowly from the scanner while pressing the needle in.
4. Remove the needle.
5. Disconnect the cable from the host device.

Power On, Sleep, Power Off, Reboot

Power on the scanner
Connect the scanner to a host device. Then the scanner will be turned on and automatically enter the sleep mode.
Enter the sleep mode
If no operation is performed on the scanner for some time, the scanner will automatically enter the sleep state.
Power off the scanner
Remove the cable from the scanner; or remove the cable from the host device; or disconnect the power adapter from
mains.
Reboot the scanner
If the scanner stops responding to input or runs abnormally, turn off the scanner and then turn it back on.
7