Parameter Setting - M&C PSS Series Instruction Manual

13

Parameter Setting

If you tap the -key after entering the PIN (see chapter "12.2 PIN Entry"), the set point for the cooler
temperature appears first. If the
to code entry. Here you can enter the codes that belong to the respective parameter settings.
You can also access the parameter setting from the main menu. To do this, keep the
until the code entry is displayed. The PIN must be active in this case.
N O T E
A code can have up to 3 digits. Single-digit codes are device-specific, two-digit codes are important
basic settings (tens digit corresponds to the channel number), three-digit codes are used for
calibration (hundreds digit: "2" stands for LA, "3" for mA calibration).
The PIN is valid for 15 minutes. If you exceed this time, the display field reappears with "0000" when
you press and hold the
If you enter an invalid code and press the
24
-key is pressed and held for a short moment, the display changes
The codes for parameter settings can be found in the appendix of this
instruction manual.
To adjust the device parameters, the code belonging to the
parameter must be entered and confirmed in this display. The left
digit of the code entry is blinking. The first digit can be entered here.
Use the und
-keys to set the individual digits.
-key. The PIN must be entered there again (see chapter "12.2 PIN Entry").
-key, the display returns to the cooler temperature.
PSS-5C | 1.02.02
-keys to switch between the digits and the
www.mc-techgroup.com
-key pressed
and