Connecting The Mx240 Router To An External Alarm-Reporting Device - Juniper MX240 Hardware Manual

NOTE:
For console devices, configure the serial port to the following values:
Baud rate—9600
Parity—N
Data bits—8
Stop bits—1
Flow control—none
Figure 76: Auxiliary and Console Ports
Figure 77: Routing Engine Console and Auxiliary Cable Connector
SEE ALSO
Routing Engine Interface Cable and Wire Specifications for MX Series Routers | 204

Connecting the MX240 Router to an External Alarm-Reporting Device

To connect the router to external alarm-reporting devices, attach wires to the RED and YELLOW relay
contacts on the craft interface. (See
yellow alarm LED on the craft interface also activates the corresponding alarm relay contact.
Figure 78 on page 260.) A system condition that triggers the red or
259