6. Lift the FPC into place and carefully align the sides of the FPC with the guides inside the card cage.
7. Slide the FPC all the way into the card cage until you feel resistance.
8. Grasp both ejector handles and rotate them clockwise simultaneously until the FPC is fully seated.
Figure 59: Reinstalling an FPC
SEE ALSO
Preventing Electrostatic Discharge Damage to an MX240 Router | 467
Tools Required to Install the MX240 Router without a Mechanical Lift
To install the router, you need the following tools and parts:
Phillips (+) screwdrivers, numbers 1 and 2
7/16-in. nut driver
ESD grounding wrist strap
Removing Components from the MX240 Router Before Installing it without
a Lift
To make the router light enough to install manually, you first remove most components from the chassis.
The procedures in this section for removing components from the chassis are for initial installation only,
SC B
SC B
231