Reinstalling The Fan Tray After Installing The Mx240 Router Without A Lift - Juniper MX240 Hardware Manual

Figure 66: Reinstalling a Power Supply

Reinstalling the Fan Tray After Installing the MX240 Router without a Lift

To reinstall the fan tray (see
1. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect the strap to
one of the ESD points on the chassis.
2. Grasp the fan tray on each side and insert it straight into the chassis. Note the correct orientation by
the "this side up" label on the top surface of the fan tray.
3. Tighten the captive screws on the fan tray faceplate to secure it in the chassis.
Figure 67: Reinstalling a Fan Tray
Figure 67 on page 240):
240