Juniper MX240 Hardware Manual page 339

e. Store the septum and screws for later use.
f. Install the MPC as described in
Figure 120: Removing the Septum
Remove four screws
on bottom.
3. If the MIC uses fiber-optic cable, verify that a rubber safety cap is over each transceiver on the faceplate.
Install a cap if necessary.
4. Pull the ejector lever above both MIC slots away from the router.
5. Align the rear of the MIC with the guides located at the corners of the MIC slot.
6. Slide the MIC into the MIC slot until it is firmly seated in the chassis.
CAUTION:
components on the MIC.
7. Verify that the ejector levers are engaged by pushing them toward the router.
8. If the MIC uses fiber-optic cable, remove the rubber safety cap from each transceiver and the end of
each cable.
WARNING:
of fiber-optic cables. Fiber-optic transceivers and fiber-optic cables connected
to a transceiver emit laser light that can damage your eyes.
"Installing an MX240 MPC" on page
Remove two
screws on top.
Slide septum
forward.
MPC
Slide the MIC straight into the slot to avoid damaging the
Do not look directly into a fiber-optic transceiver or into the ends
350.
343