Table of Contents
Advertisement
Installing the server and peripheral devices
2. Locate the external SCSI terminator (included loose within the server shipping
Caution:
It is imperative that you install the terminator to ensure reliable server operation. Failure to
do so will result in an inability to load the operating system.
Connect peripheral devices as described in this chapter.
What is next?
Connect peripheral devices as described in this chapter.
Connecting peripherals to the server
Rear panel connectors
The following diagram shows the connectors on the rear panel of the 600r.
30
Avaya CallPilot® 600r Server Hardware Installation
Note:
The DS30X cable that connects the NTRH40AA MPB96 board to the MGate
cards is 20 m (60 feet) long. With this cable, you can place the server in a different
room from the Meridian 1 switch or Avaya Communication Server 1000 system.
The DS30 cables that connect the NTRH40CA MPB96 board to the NTRB18DA
MGate cards can be up to 600 m (1968 feet) long. With this cable you can place
the server in a different building from the Meridian 1 switch or Avaya CS 1000
system.
carton). Connect the terminator to the rear SCSI port labeled C in
panel
on page 31. For an illustration of the SCSI terminator, see the item labeled
Server terminator in
Figure 8: SCSI tape drive with terminator
Figure 7: Rear
on page 33.
December 2010
Advertisement
Table of Contents
