Table of Contents
Advertisement
Figure 7: Rear panel
Table 5: Rear panel connectors
Label
A
USB 0, USB 1, USB 2
(labelled 0, 1, 2 on server)
B
PS/2 Mouse
C
SCSI port
D
PCI card bracket (full-
height) for MPB96
E
Power supply
F
AC power input
To connect the mouse, keyboard, and monitor to the server
1. Place the monitor, keyboard, and mouse in the same location as the server.
2. Plug the keyboard and mouse into the appropriate PS/2 connectors on the chassis
3. Plug in the monitor connector (see diagram, label J). Tighten the screws on the
4. Connect the power cord to the monitor and plug the other end into a wall receptacle
5. Turn on the monitor.
Avaya CallPilot® 600r Server Hardware Installation
Description
rear panel. See labels L and B, respectively, on the diagram.
connector.
or power bar.
To connect the mouse, keyboard, and monitor to the server
Label
G
Ground studs (used with system with DC
input power supply)
H
RJ45 NIC 2 ELAN connector (labelled 2 on
server)
I
RJ45 NIC 1 CLAN connector (labelled 1 on
server)
J
Video connector
K
COM1 DB-9 serial port
L
PS/2 Keyboard connector
Description
December 2010
31
Advertisement
Table of Contents
