Table of Contents
Advertisement
Connecting the server to power
Before you connect the server to the power source, review the following diagram and the
warning that follows to ensure that all peripheral hardware devices are in place.
Figure 13: Example setup of 600r with peripherals
To connect the 600r server to power
Warning:
Risk of personal injury and risk of hardware failure
You must connect the power outlets that are used by the CallPilot server and its peripheral
devices to the same single-point ground reference as the one used by the switch with MGate
cards connected to the CallPilot server.
If this requirement is not met, power transients can cause personal injury, hardware failure,
or both. For more information about single-point grounding requirements, seeInstallation
and Configuration Task List (NN44200-306).
44
Avaya CallPilot® 600r Server Hardware Installation
December 2010
Advertisement
Table of Contents
