Table of Contents
Advertisement
Preparing for installation
Unpacking the 1005r server
Introduction
Follow this procedure to unpack the server and peripherals.
Warning:
Risk of personal injury
The 1005r CallPilot server weighs approximately 20 kg (44 lb) when it is shipped from
manufacturing. To prevent personal injury, have someone help you to unpack and position
the server.
To unpack the equipment
1.
2. Remove the server from the carton; set it on a secure surface.
3. Open the cartons containing the monitor, keyboard, mouse, modem, and ELAN
4. Remove the dongle from the box and set it aside
5. Put all manuals, DVDs or CDs, operating system disks, and any disks for peripherals
6. Save all packing materials and cartons in case you must return any equipment to
What is next?
Remove the front bezel cover so that you can inspect the front panel of the server. See
Removing the front bezel
28
Avaya CallPilot® 1005r Server Hardware Installation
Important:
As you unpack each item, check it off against the packing list, as well as against
the following checklists provided in the Installation and Configuration Task List
(NN44200-306):
• "CallPilot software media and documentation checklist"
• "CallPilot server hardware checklist"
Open the cardboard carton containing the server.
Ethernet switch or hub (if supplied), and set the peripherals aside.
in a safe place.
the carrier.
on page 29.
December 2010
Advertisement
Table of Contents
