Warning, Caution And Note Definition; General Warnings And Cautions - Newport XPS-D Startup Manual

XPS-D Controller
1.3

Warning, Caution and Note Definition

The following are definitions of the Warnings, Cautions and Notes that may be used in
this manual to call attention to important information regarding personal safety, safety
and preservation of the equipment, or important tips.
Situation has the potential to cause bodily harm or death.
Situation has the potential to cause damage to property or
equipment.
Additional information the user or operator should consider.
1.4

General Warnings and Cautions

The following general safety precautions must be observed during all phases of
operation of this equipment.
Failure to comply with these precautions or with specific warnings elsewhere in this
manual violates safety standards of design, manufacture, and the intended use of the
equipment.
• Only properly trained personnel should use this device
• Heed all warnings on the unit and in the operating instructions.
• To prevent damage to the equipment, read the instructions in this manual for the
selection of the proper input voltage.
• Use only the provided plug and the main cable specified for this product and
certified for the country of use.
• Ensure that the equipment is properly grounded to earth ground through the
grounding lead of the AC main cable.
• Route cables where they are not likely to be damaged.
• Keep permanent access to the wall inlet or to the main switching device.
• The system must be installed in such a way that the power switch and the power
connector at the rear remain accessible to the user.
• Disconnect or do not plug-in the AC power cord under the following conditions:
– If the AC power cord or any other attached cables are frayed or damaged.
– If the power plug or receptacle is damaged.
– If the unit is exposed to rain or excessive moisture, or liquids are spilled on it.
– If the unit has been dropped or the case is damaged.
– If the user suspects service or repair is required.
• Keep air vents free of dirt and dust and obstructions.
• Keep liquids away from unit.
• Do not expose equipment to moisture exceeding specification.
• Do not operate this equipment in an explosive atmosphere.
• Disconnect power before cleaning the Controller/Driver unit. Do not use liquid or
aerosol cleaners.
WARNING
CAUTION
NOTE
3
Start-Up Manual
EDH0395En1031 – 09/18