SMC100CC & SMC100PP
SMC100
Single-Axis Motion Controller
1.0
Introduction
EDH0206En2042 – 04/16
1.1
Definitions and Symbols
The following terms and symbols are used in this documentation and also appear on the
SMC100 Controller/Driver where safety-related issues occur.
1.1.1
General Warning or Caution
The Exclamation Symbol in Figure 1 may appear in Warning and Caution tables in this
document. This symbol designates an area where personal injury or damage to the
equipment is possible.
1.1.2
Electric Shock
The Electrical Shock Symbol in Figure 2 may appear on labels affixed to the SMC100
Controller/Driver. This symbol indicates a hazard arising from dangerous voltage. Any
mishandling could result in irreparable damage to the equipment, in personal injury, or
death.
1.1.3
European Union CE Mark
The presence of the CE Mark on Newport Corporation equipment means that it has
been designed, tested and certified as complying with all applicable European Union
(CE) regulations and recommendations.
Single-Axis Motion Controller/Driver for DC or Stepper Motor
Figure 1: General Warning or Caution Symbol.
Figure 2: Electrical Shock Symbol.
Figure 3: CE Mark.
1