Mounting The Vvt Bypass Ii; To Mount The Controller And Actuator - Carrier VVT Bypass II Installation And Startup Manual

Mounting the VVT Bypass II

Mount the VVT Bypass II on the bypass duct damper actuator shaft. For service access, allow at least 1 foot (.3 m)
of clearance between the front of the controller and adjacent surfaces.

To mount the controller and actuator

To disconnect and mount the controller and actuator separately
VVT Bypass II Controller
Installation and Start-up Guide
7
Installing the VVT Bypass II
CARRIER CORPORATION ©2019
All rights reserved