WAGO-I/O-SYSTEM 750
750-512 2DO 230V AC 2.0A/ Relay 2NO
Pos : 62 /All e Seri en ( Allgemei ne Module)/Ü bers chriften für alle Serien/Ansc hließ en/Geräte ansc hließ en - Ü bersc hrift 1 @ 3\mod_1234172889468_21.doc @ 27460 @ 1 @ 1
5
Connect Devices
Pos : 63 /Serie 750 ( WAGO-I/O-SYST EM)/Ans chli eßen/Lei ter an C AGE C LAM P ansc hließen - Ü bers chrift 2 und T ext @ 3\mod_1225448660171_21.doc @ 24928 @ 2 @ 1
5.1
Connecting a Conductor to the CAGE CLAMP
The WAGO CAGE CLAMP
finely stranded conductors.
Only connect one conductor to each CAGE CLAMP
Only one conductor may be connected to each CAGE CLAMP
Do not connect more than one conductor at one single connection!
If more than one conductor must be routed to one connection, these must be
connected in an up-circuit wiring assembly, for example using WAGO feed-
through terminals.
Exception:
If it is unavoidable to jointly connect 2 conductors, then you must use a ferrule to
join the wires together. The following ferrules can be used:
Length
Nominal cross section
WAGO Product
1.
To open the CAGE CLAMP
above the connection.
2.
Insert the conductor into the corresponding connection opening.
3.
To close the CAGE CLAMP
then clamped firmly in place.
Figure 10: Connecting a conductor to a CAGE CLAMP
Pos : 64 /D okumentation allgemei n/Glieder ungs elemente/---Seitenwec hs el--- @ 3\mod_1221108045078_0.doc @ 21810 @ @ 1
Manual
Version 1.2.0
®
connection is appropriate for solid, stranded and
8 mm
2
1 mm
for 2 conductors with 0.5 mm
max.
216-103 or products with comparable properties.
®
insert the actuating tool into the opening
®
simply remove the tool - the conductor is
Connect Devices
®
connection!
®
connection.
®
27
®
2
each