Inserting And Removing Devices; Inserting I/O Module; Figure 7: Insert I/O Module - WAGO -I/O-SYSTEM 750 Series Manual

WAGO-I/O-SYSTEM 750
750-512 2DO 230V AC 2.0A/ Relay 2NO
Pos : 60.7 /Serie 750 (WAGO-I/O-SYST EM)/M ontieren/Ger äte einfügen und entfer nen - Ü berschrift 2 @ 3\mod_1231768483250_21.doc @ 25950 @ 2 @ 1
4.2

Inserting and Removing Devices

Pos : 60.8 /Serie 750 (WAGO-I/O-SYST EM)/Wic htige Erläuterungen/Sic herheits- und sonstige Hinweis e/Gefahr/Gefahr: Vorsic ht bei der U nterbrechung von F E! @ 6\mod_1256193919214_21.doc @ 43423 @ @ 1
Use caution when interrupting the PE!
Make sure that people or equipment are not placed at risk when removing an I/O
module and the associated PE interruption. To prevent interruptions, provide ring
feeding of the ground conductor, see section "Grounding/Ground Conductor" in
manual "System Description WAGO-I/O-SYSTEM 750".
Pos : 60.9 /All e Serien ( Allgemei ne Module)/Wic htige Erläuterungen/Sicherheits- und sonstig e Hinweis e/Achtung/Achtung: Arbeiten an Ger äten nur s pannungsfrei durchführen! @ 6\mod_1256193963573_21.doc @ 43426 @ @ 1
Perform work on devices only if the system is de-energized!
Working on devices when the system is energized can damage the devices.
Therefore, turn off the power supply before working on the devices.
Pos : 60.10 /Serie 750 ( WAGO-I/O- SYST EM)/Monti eren/Bus kl emme ei nfügen @ 3\mod_1231769726703_21.doc @ 25989 @ 3 @ 1
4.2.1

Inserting I/O Module

1. Position the I/O module so that the tongue and groove joints to the fieldbus
coupler/controller or to the previous or possibly subsequent I/O module are
engaged.

Figure 7: Insert I/O module

2. Press the I/O module into the assembly until the I/O module snaps into the
carrier rail.
Manual
Version 1.2.0
Mounting 25