Secondary Pmcspan Installation - Motorola MVME2400 Series Installation And Use Manual

5. Place the PMCspan on top of the MVME240x module. Align the
6. Gently press the PMCspan and MVME240x together, making sure
7. Insert the four short Phillips screws through the holes at the corners
Note

Secondary PMCspan Installation

The PMCspan-010 PCI expansion module mounts on top of a
PMCspan-002 PCI expansion module. To install a PMCspan-010 on your
MVME240x, refer to
Note
1. Attach an ESD strap to your wrist. Attach the other end of the ESD
2. Perform an operating system shutdown. Turn the AC or DC power
http://www.motorola.com/computer/literature
mounting holes in each corner to the standoffs, and align PMCspan
connector P4 with MVME240x connector J6.
that P4 is fully seated in J6.
of the PMCspan and into the standoffs on the MVME240x module.
Tighten the screws.
The screws have two different head diameters. Use the screws
with the smaller heads on the standoffs next to VMEbus
connectors P1 and P2.
Figure 1-5
This procedure assumes that you have read the user's manual that
was furnished with the PMCspan, and that you have installed the
selected PMCs on the PMCspan according to the instructions
given in the PMCspan and PMC manuals.
strap to the chassis as a ground. The ESD strap must be secured to
your wrist and to ground throughout the procedure.
off and remove the AC cord or DC power lines from the system.
Remove chassis or system cover(s) as necessary for access to the
VME modules.
Hardware Installation
and perform the following steps:
1
1-17