Installing A Secondary Pmcspan - Motorola MVME2300 Series Installation And Use Manual

4. Attach the four standoffs to the module. For each standoff:
5. Place the PMCspan on top of the module. Align the mounting holes
6. Gently press the PMCspan and the module together, ensuring that
7. Insert the four short Phillips screws through the holes at the corners
Note

Installing a Secondary PMCspan

The PMCspan-010 PCI expansion module mounts on top of a PMCspan-
002 PCI expansion module. To install a PMCspan-010 on your
MVME2300, refer to
procedure assumes that you have read the user's manual that was furnished
with the PMCspan, and that you have installed the selected PMCs on the
PMCspan according to the instructions given in the PMCspan and PMC
manuals.
Inserting or removing modules with power applied may result in damage
to module components.
!
Avoid touching areas of integrated circuitry; static discharge can damage
Caution
these circuits.
1-17
– Insert the threaded end into the standoff hole at each corner of
the VME processor module.
– Thread the locking nuts onto the standoff tips.
– Tighten the nuts with a box-end wrench or a pair of needle nose
pliers.
in each corner to the standoffs, and align PMCspan connector P4
with connector J18 on the module.
P4 is fully seated into J18.
of the PMCspan and into the standoffs on the module. Tighten the
screws.
The screws have two different head diameters. Use the screws
with the smaller heads on the standoffs next to VMEbus
connectors P1 and P2.
Figure 1-5
Installing the MVME2300 Hardware
and perform the following steps. This
1