10/100BaseT Port
The RJ-45 port on the front panel of the MVME240x labeled
supplies the Ethernet LAN 10BaseT/100Base TX interface, implemented
with a DEC 21140/21143 device.
Similarly, the Universe ASIC supplies an input signal and a control bit to
initiate a local reset operation. By setting a control bit, software can
maintain a board in a reset state, disabling a faulty board from participating
in normal system operation. The local reset driver is enabled even when
the Universe ASIC is not system controller. Local resets may be generated
by the
SYSRESET*, or a control bit in the MISC_CTL register.
DEBUG Port
The RJ-45 port labeled
supplies the MVME240x serial communications interface, implemented
via a UART PC16550 controller chip from National Semiconductor. It is
asynchronous only. This serial port is configured for EIA-232-D DTE, as
shown in
The
DEBUG
to serve as the firmware console for the factory installed debugger,
PPCBug. The port is configured as follows:
After power-up, the baud rate of the
using the debugger's Port Format (PF) command. Refer to
PPCBug
the PPCBug.
http://www.motorola.com/computer/literature
switch, a power-up reset, a watchdog timeout, a VMEbus
RST
DEBUG
Figure
2-2.
port may be used for connecting a terminal to the MVME240x
8 bits per character
1 stop bit per character
Parity disabled (no parity)
Baud rate = 9600 baud (default baud rate at power-up)
and
Chapter 6, Environment Modification
on the front panel of the MVME240x
port can be reconfigured by
DEBUG
for information about
Applying Power
10/100 BASET
Chapter 5,
2-5
2
Need help?
Do you have a question about the MVME2400 Series and is the answer not in the manual?
Questions and answers