Mvme240X Installation - Motorola MVME2400 Series Installation And Use Manual

Hardware Preparation and Installation
1

MVME240x Installation

!
Caution
!
Warning
1-20
Before installing the MVME240x into your VME chassis, ensure that the
jumpers on the MVME240x J8, J9, and S3 switch are configured, as
previously described. This procedure assumes that you have already
installed the PMCspan(s) if desired, and any PMCs that you have selected.
Proceed as follows to install the MVME240x in the VME chassis:
1. Attach an ESD strap to your wrist. Attach the other end of the ESD
strap to the chassis as a ground. The ESD strap must be secured to
your wrist and to ground throughout the procedure.
2. Perform an operating system shutdown. Turn the AC or DC power
off and remove the AC cord or DC power lines from the system.
Remove chassis or system cover(s) as necessary for access to the
VME modules.
Inserting or removing modules with power applied may result in damage
to module components.
Dangerous voltages, capable of causing death, are present in this
equipment. Use extreme caution when handling, testing, and adjusting.
3. Remove the filler panel from the card slot where you are going to
install the MVME240x. If you have installed one or more PMCspan
PCI expansion modules onto your MVME240x, you will need to
remove filler panels from one additional card slot for each
PMCspan, above the card slot for the MVME240x.
– If you intend to use the MVME240x as system controller, it must
occupy the left-most card slot (slot 1). The system controller
must be in slot 1 to correctly initiate the bus-grant daisy-chain
and to ensure proper operation of the IACK daisy-chain driver.
– If you do not intend to use the MVME240x as system controller,
it can occupy any unused card slot.
Computer Group Literature Center Web Site